bellett.net
https://www.bellett.net/forums/

suspension arm dimensions
https://www.bellett.net/forums/viewtopic.php?f=35&t=3788
Page 1 of 1

Author:  Kombat [ Mon Aug 08, 2022 11:32 pm ]
Post subject:  suspension arm dimensions

hi all

going to be turning up some new front end bushings in the lathe in the nearish future

i was just wondering whether anyone either has a drawing of the relevant measurements for upper and lower control arm bushes or some under the bench they could measure up for me, if i can avoid it would prefer not to have to pull the front end apart just yet

cheers
Aiden

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/