| bellett.net https://www.bellett.net/forums/ |
|
| Clutch release query https://www.bellett.net/forums/viewtopic.php?f=36&t=3043 |
Page 1 of 1 |
| Author: | Asroc66 [ Sun May 17, 2015 5:17 am ] | ||
| Post subject: | Clutch release query | ||
Hi All, I am having a tidy-up and noticed I have 3 differing length for clutch release/spigot bearings I am lead to believe the shorter is for the origional 64-65 clutches which are different in design to later/modern clutches Can someone please set me straight why short/medium/ long in the carriers Many thanks J
|
|||
| Author: | flying [ Sun May 17, 2015 11:07 pm ] |
| Post subject: | Re: Clutch release query |
Hi J The longest one looks similar to my original gt setup I am using the smaller one in the twin cam 5 speed set up with modifying the ID to suit the large carrier brg Diameter. Not sure about the intermediate length unit. Hope this helps Flying |
|
| Author: | Asroc66 [ Wed May 13, 2020 4:52 am ] |
| Post subject: | Re: Clutch release query |
Greetings all from Tassie Hope all are surviving the Covid challenge.... Would someone please send me a photo of a GT Carrier I think the centre one in the photo is from a 1969 pr20 I pulled out of a paddock in St Mary’s with Yellow Peril...... So would that be the same or the longer one left of photo be from the GT Many thanks J |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|