 |
 |
 |
|
Page 1 of 1
|
[ 3 posts ] |
|
Bellet Chassis Dimensions
| Author |
Message |
|
RobSA
Joined: Sat Sep 26, 2009 10:55 am
Posts: 580
Location: Adelaide
Car(s): BA Falcon, 68 Bellett
|
Hi Belletters,
Just asking if anyone has the chassis dimensions for straightening or making sure one is square and true.
I'm sure one must exist but apart trolling through every Bellett catalogue, I was hoping someone would know where to look first.
Cheers
Rob
_________________
If you can't fix it with a hammer, you have an electrical problem!
|
| Sat May 30, 2015 4:25 am |
|
|
|
CQGT
Joined: Sun Dec 12, 2010 10:04 am
Posts: 386
Location: Boyne Island.Gladstone. Queenland
Car(s): '70 PR91,'69 PR20 x 2,'66 PR20,'65? KR20's x 2,'66 ? PR90,2012 d22 STR Navarra.
|
Hey Rob.
Never ever come accross any dimensions. The only way your going to find out, as I have done,
was on a sedan with the the front and rear suspensions in. Finding a good bare shell will be imposible.
My convertible was involved in a prang before I bought it and the LH side rail was completly rusted out.
Had to know if it was 'true' or not.
Nissan started to bring this techknology out about 25 years ago for the panel beaters with the car aligner.
Dave.
_________________
CQGT.
I'm the Dave with the convertible.
|
| Sat May 30, 2015 12:55 pm |
|
|
|
Asroc66
Joined: Tue Jun 18, 2013 5:09 am
Posts: 428
Location: Sydney NSW
Car(s): PR91 1967 GT, PR20 1966 1/2 with GT Goodies
|
Does this help
mm inches
Wheelbase 2352 92.6
Track/tread (front) 1219 48
Track/tread (rear) 1214 47.8
Length 4006 157.7
Width 1496 58.9
Height 1341 52.8
Cheers
J
_________________
To increase the fun, add a hair dryer
|
| Sun May 31, 2015 10:05 pm |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 12 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
|
|
