Has any one got one they can sell me, i need to get some extractors made. I know there was a bunch of them made somewhere on bellett.net a year or two ago. PM me
Cheers Craig
Gt exhaust manifold faceplate
-
Stickman
- Posts: 1523
- Joined: Fri Apr 10, 2009 11:29 pm
- Car(s): 3x1965 PR20(Donkey, Jenny n Bundy) 1 1969 PR20(Percy) 2 1968 PR20(Eugine n GT Donor) 1 1968 PR91 GT, 1 1965 Wasp
- Location: Kallangur, Brisbane QLD
- Contact:
Re: Gt exhaust manifold faceplate
That was about 4 years ago when they were made and I believe (early 2013 maybe) they were only made in the numbers for those who put their hands up and put money forward at the time. Plenty said they were keen but only a few put their hands in their pockets.
All long gone now.
Any decent exhaust shop could make one for you though if you have a std manifold to make a template for the faceplate from.
I got a set done for one of my sedans from scratch a while back, cost me about $700 inc new muffler and exhaust to rear.
All long gone now.
Any decent exhaust shop could make one for you though if you have a std manifold to make a template for the faceplate from.
I got a set done for one of my sedans from scratch a while back, cost me about $700 inc new muffler and exhaust to rear.
1xB+1xE+2xL+1xE+2xT=BELLETT
RUST isn't a crime
www.gartdesign.com.au
RUST isn't a crime
www.gartdesign.com.au
-
67GT
- Posts: 348
- Joined: Sun Jun 14, 2009 8:44 am
- Car(s): 1967 bellett gt, wasp trayback , 2018 d-max 4x4 dual cab LSU, 2016 Focus, 1996 GQ Patrol
- Location: central coast
Re: Gt exhaust manifold faceplate
Hi Craig, Sticky's right, I had one made from scratch to suit the Florian head on my Wasp. The whole lot cost me $800.
If you have one already, just blown out like my GT one, it should be a lot cheaper. They can simply make new pipes to fit your mounting face. Laser cutting the mounting plate is where the cost goes up.
If you have one already, just blown out like my GT one, it should be a lot cheaper. They can simply make new pipes to fit your mounting face. Laser cutting the mounting plate is where the cost goes up.